USB Connector Board features a USB connector that allows easy connection between a prototype device and USB devices.
CAN Board is a development tool for microcontrollers with integrated MCP2551 CAN transceiver used in connection with CAN network.
CANSPI Board is a CAN development tool for microcontrollers with SPI interface. The Board includes MCP2551 CAN controller and MCP2551 transceiver.
The EasyPS/2 Board enables your development board to be connected to a PS/2 device. There is an on-board PS/2 connector used to establish PS/2 communication. The board also features a DIP switch used to configure board connections.
Ethernet Connector Boards include a 10/100 Base-Transformer RJ45 connector that enables you to easily connect your prototype board to the Ethernet network.
The IrDA-To-PC Board is used to enable a PC to use IrDA communication. The board features MCP2120 along with TFDU4101 diode and other electronics required for connecting a PC to other IrDA devices.
The LIN Board is a full-featured board for LIN bus. It includes a LIN bus transceiver MCP201 providing a physical interface between a microcontroller and LIN half-duplex bus. It is intended for use in automotive and industrial applications.
MAX232 Boards are used to connect the MAX232 circuit to a prototype board.
The MAX3232 Board is used for establishing RS232 communication with devices powered from 3.0V to 5.5V power supply.
The mikroETH100 Board is an accessory board that contains ENC624J600 (stand-alone 10/100 Base-T Ethernet interface controller with integrated MAC & PHY, 24-Kbyte RAM buffer). Board is designed to serve as an Ethernet network interface for any microcontroller equipped with SPI
PS/2 Connector Board is accessory board used to connect PS/2 devices to a prototype device. There is a PS/2 connector provided on the board. It enables PS/2 communication.
RS485 Board is a tool for developing devices that use RS485 communication. The on-board ADM485 differential line transceiver is suitable for high speed bidirectional data communication on multipoint bus transmission lines.
Microchip's ENC28J60 is a 28-pin, 10BASE-T stand alone Ethernet Controller with an on-board MAC & PHY, 8 Kbytes of Buffer RAM and SPI serial interface.
The Serial Ethernet 2 Board is an accessory board that contains ENC624J600 (stand-alone 10/100 Base-T Ethernet interface controller with integrated MAC & PHY, 24-Kbyte RAM buffer). Board is designed to serve as an Ethernet network interface for any microcontroller equipped with SPI.
The SIM Card Holder Board enables you to connect a prototype device to a SIM card. Connection can be established in a few simple steps. The board solves your prototyping problems by offering a complete and cost-effective solution.
The USB UART Board is a prototype board that features a USB support with an on-board USB to serial UART interface device FT232R. There is also a jumper used for selecting VCC output level provided on the board.
The USB UART 2 Board is a prototype board that features a USB-to-UART serial converter MCP2200 which enables USB connectivity for prototype devices that have a UART interface. The board also features a USB Connector.
This I2C to USB adapter is specifically built for connecting our Gesture Board to a PC.
The Port Expander Board is an accessory board that includes a 16-bit I/O expander MCP23S17. This expander employs SPI(tm) clock up to 10 MHz. The board is ideal for expanding number of microcontroller pins on your prototype device.