The kit comprises a RS485 click 3.3V, WiFi3 click, ETH click and a BLE P click, so you can build a smartphone app and tinker with your lights whenever you want.
This product is no longer in stock
Turn up the lights in here, baby; extra bright, I want y'all to see this. It’s a click pack for designing a DMX512 controller. That means stage lights, disco lights, or a really cool LED installation in your living room. The kit comprises a RS485 click 3.3V, WiFi3 click, ETH click and a BLE P click, so you can build a smartphone app and tinker with your lights whenever you want.
ETH Click is an accessory board in mikroBus™ form factor. It features ENC28J60, a 28-pin, 10BASE-T stand alone Ethernet Controller with an on-board MAC & PHY, 8K Bytes of Buffer RAM and SPI serial interface.
RS485 click 3.3V carries the SN65HVD12 half-duplex, RS-485 transceiver from Texas Instruments. It is designed for balanced data transmission and complies with EIA standards RS-485 and RS-422. The click is designed to run on a 3.3V power supply. RS485 5V click communicates with the target microcontroller over UART interface, with additional functionality...
BLE P click carries the nRF8001 IC that allows you to add Bluetooth 4.0 to your device. The click communicates with the target board MCU through mikroBUS™ SPI (CS, SCK, MISO, MOSI), RDY and ACT lines, and runs on 3.3V power supply.
WiFi3 click is a complete self-contained WiFi solution carrying the ESP8266 module with a system on a chip. The click is designed to run on a 3.3V power supply only. It communicates with the target board microcontroller through the mikroBUS™ RX, TX, CS and RST lines.