Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart. There is 1 item in your cart.
Total products
Total shipping  To be determined
Total
Continue shopping Proceed to checkout

SPI Isolator click

MIKROE-2583

SPI Isolator click carries the ADuM4154 5kV digital isolator optimized for a serial peripheral interface (SPI). The click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over SPI interface.

More details

$29.00

Quantity Unit Price
5 $27.55
20 $26.10
SPI Isolator click carries the ADuM4154 5kV digital isolator optimized for a serial peripheral interface (SPI). The click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over SPI interface.

ADuM4154 features

The ADuM4154 has four high-speed channels. The first three channels, CLK, MI/SO, and MO/SI (the slash indicates the connection of the particular input and output channel across the isolator) are optimized for either low propagation delay in the B grade, or high noise immunity in the A grade.

Note: For more information about the A and B grade specifications see the datasheet.
Take a look at how the click can be connected in the picture below:

Note: For this example we used the ccRF 3 click and the EasyPIC v7 development board

SPI communication

SPI (Serial Peripheral Interface) communication is one of the most popular protocols for sending data between microcontrollers and different peripherals.

It is a synchronous protocol; the clock signal is provided by the master.

For more information take a look at our Learn article about SPI communication.

Key features

  • ADuM4154 module
    • Supports up to 17 MHz SPI clock speed
    • 4 high speed, low propagation delay, SPI signal isolation channels
  • SPI interface
  • 3.3V or 5V power supply

Downloads

Product Type SPI isolator
Applications Sensor isolation, industrial programmable logic controllers (PLCs)
MCU ADuM4154 digital isolator optimized for SPI
Key Features The module supports up to 17 MHz SPI clock speed, 4 high speed, low propagation delay, SPI signal isolation channels
Key Benefits The ADuM4154 supports up to 4 slave devices
Interface SPI
Power Supply 3.3V or 5V
Compatibility mikroBUS

Pinout diagram

This table shows how the pinout on SPI Isolator click corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns).

Notes Pin Mikrobus logo.png
mikroBUStm
Pin Notes
Not connected NC 1 AN PWM 16 NC Not connected
Not connected NC 2 RST INT 15 NC Not connected
Slave Select from the Master MSS 3 CS TX 14 NC Not connected
SPI Clock from the Master Controller MCLK 4 SCK RX 13 NC Not connected
SPI Data from the Slave to the Master MI/SO Line MI 5 MISO SCL 12 NC Not connected
SPI Data from the Master to the Slave MO/SI Line MO 6 MOSI SDA 11 NC Not connected
Power supply +3.3V 7 3.3V 5V 10 +5V Power supply
Ground GND 8 GND GND 9 GND Ground

You Might Also Need

Products in the same category

Send a message

SPI Isolator click

SPI Isolator click

What can we do for you?