20%
OFF
MIKROE-1303
6 g
Status:
mikroProg to ST-Link v2 adapter allows you to connect mikroProg for STM32 programmer and hardware debugger to 20-pin male JTAG connector on your target board. Adapter is consisted of one 2x10 male header and a 2x10 female socket.
This product is no longer in stock
Availability date:
20%
OFF
mikroProg to ST-Link v2 adapter allows you to connect mikroProg for STM32 programmer and hardware debugger to 20-pin male JTAG connector on your target board. Adapter is consisted of one 2x10 male header and a 2x10 female socket. It’s recommended to first place the adapter on 2x10 male header on the target board, and then plug in the mikroProg™ into the adapter’s 2x5 male header.
Type | Adapter |
Applications | Adapter allows you to connect mikroProg for STM32 programmer and hardware debugger to 20-pin male JTAG connector on your target board |
On-board modules | 2x10 male header and a 2x10 female socket |
Interface | GPIO |
Compatibility | IDC10 |
NOTE: Please be advised that any peripheral devices or accessories shown connected to the Click board™ are not included in the package. Check their availability in our shop or in the YMAN section below.