SPI Isolator click carries the ADuM4154 5kV digital isolator optimized for a serial peripheral interface (SPI).
The click is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over SPI interface.
This product is no longer in stock
The ADuM4154 has four high-speed channels. The first three channels, CLK, MI/SO, and MO/SI (the slash indicates the connection of the particular input and output channel across the isolator) are optimized for either low propagation delay in the B grade, or high noise immunity in the A grade.
SPI (Serial Peripheral Interface) communication is one of the most popular protocols for sending data between microcontrollers and different peripherals.
It is a synchronous protocol; the clock signal is provided by the master.
For more information take a look at our Learn article about SPI communication.
|Applications||Sensor isolation, industrial programmable logic controllers (PLCs)|
|MCU||ADuM4154 digital isolator optimized for SPI|
|Key Features||The module supports up to 17 MHz SPI clock speed, 4 high speed, low propagation delay, SPI signal isolation channels|
|Key Benefits||The ADuM4154 supports up to 4 slave devices|
|Input Voltage||3.3V or 5V|
|Click board size||M (42.9 x 25.4 mm)|
This table shows how the pinout on SPI Isolator click corresponds to the pinout on the mikroBUS™ socket (the latter shown in the two middle columns).
|Slave Select from the Master||MSS||3||CS||TX||14||NC|
|SPI Clock from the Master Controller||MCLK||4||SCK||RX||13||NC|
|SPI Data from the Slave to the Master MI/SO Line||MI||5||MISO||SCL||12||NC|
|SPI Data from the Master to the Slave MO/SI Line||MO||6||MOSI||SDA||11||NC|
|Power supply||+3.3V||7||3.3V||5V||10||+5V||Power supply|