15% OFF on everything in the shop - the offer lasts until June 27, 12:00 CET. Discount applies at checkout
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart. There is 1 item in your cart.
Total products
Total shipping  To be determined
Total
Continue shopping Proceed to checkout

VREG click

MIKROE-2443

32 g

VReg click is a digitally controlled DC Voltage regulator in mikroBUS™ form factor. The design is based on the well-known LM317 circuit, with the addition of a 12-bit DAC, 12-bit ADC, and an Operational Amplifier. Two pairs of screw terminals serve as inputs and outputs.

More details

$24.00

Quantity Unit Price
5 $22.80
20 $21.60

The LM317 IC is a reliable regulator with typical line regulation of 0.01% and load regulation of 0.1%. It also has internal short-circuit current limiting and thermal overload protection.

The circuit regulates voltage by turning all input/output difference into heat (effectively dissipating all the excess power). If it gets too hot it may damage the board or cause unexpected behaviour.

Because of that, the board’s operating range is defined by two factors. 1) maximum input voltage and current (should not exceed 20V/1A); and 2) maximum wattage arising from current and I/O voltage difference (should not exceed 2W, measured as I x (Input V - Output V).

The board also carries a MOSFET chip to toggle the output on and off.

VReg click communicates with the target board MCU through the SPI interface (CS, SCK, MISO, MOSI). The board can use either a 3.3V or a 5V power supply. 

It is also possible to use the board’s power supply as the Input, by resoldering the onboard INPUT SEL jumper.

Downloads

Type Voltage regulator
Applications Regulating linear power supplies for a wide variety of devices
On-board modules LM317, MCP4921 12-bit DAC, MCP3204 12-bit ADC, ZXMP7A17K MOSFET, LMx58 Low-Power, Dual-Operational Amplifier
Key Features Input Output screw terminals
Key Benefits Digital control, Possible to use board’s power supply as input
Interface SPI
Power Supply 3.3V or 5V
Compatibility mikroBUS
Click board size L (57.15 x 25.4 mm)

Programming

The following code snippet shows how to send temperature readings from VReg click to a TFT display.

 1 while(1)
 2 {
 3     if(output < set_value)
 4     {
 5         value = value + 1;
 6         if(value>4095) {value = 4095;}
 7     }
 8     
 9     if(output > set_value)
10     {
11         value = value - 1;
12         if(value<1) {value = 2;}
13     }
14     
15     DAC_Output(value);
16     output = getADC(1)/1.82;
17     ProcessValue(output,2);   // Writes measured value to Lcd
18     Delay_ms(10);                  // Wait 10ms
19   
20 }

Code examples that demonstrate the usage of VReg click with MikroElektronika hardware, written for mikroC for ARM, AVR, dsPIC, FT90x, PIC and PIC32 are available on [Libstock].

You Might Also Need

Products in the same category

Send a message

VREG click

VREG click

What can we do for you?